Troken Roof-T paint for concrete, ceramic, cement and asbestos roof tiles

Troken Roof-T roof paint is a water-based product intended for painting roofs and other outdoor surfaces, such as eternit and ligno-cement boards, fences, terraces, pillars and spans.

The paint can be used on various building materials, including plaster, concrete, and brick.

Troken Roof-T is available in many colors from the RAL color palette, which look aesthetically pleasing on roof surfaces.

The most important properties of Troken Roof-T roof paint:

• provides good coverage,

• creates a smooth, uniform and flexible coating with a satin finish,

• durable and waterproof,

• washable – you can remove dirt without worrying about damaging the roof paint,

• on concrete substrates - limits the penetration of atmospheric gases into the concrete, which can cause corrosion of the reinforcement.

How to apply Troken Roof-T roof paint

Preparation of the substrate

The substrate should be sound and clean – free of grease and dust.
The surface should be thoroughly dedusted and degreased, and any cement laitance that may have formed on the substrate should be removed.

Renovation of old roofs - mosses and lichens on the roof should be removed manually, and the remains should be washed off with GrzyboStop fungicide 24 hours before priming and thoroughly rinsed with water under pressure.

Surfaces with old coatings should be cleaned with Sulfanol A using a brush or sponge. Then rinse thoroughly with water and ensure there are no traces of the preparation on the surface, as this may impair paint adhesion.

Heavily chalked roof surfaces may require sandblasting. After sandblasting, clean as described in the previous section.

Smooth surfaces should be roughened with sandpaper. Then clean as you would with old coated surfaces.

The thickness of the layer on the roof tiles should be at least 0.1 mm - otherwise the paint coating will not provide sufficient protection.

Important information about paint for concrete, ceramic, cement and asbestos roof tiles

• Do not paint wet or hot surfaces,

• Until the paint is completely dry, protect the painted surface from rain and frost,

• Do not add chalk, lime, solvents or pigments to the paint,

• The paint drying times and time intervals between applying subsequent coats are based on a substrate temperature of +20 °C and a relative air humidity of 60%. Lower temperatures and higher humidity extend the drying time of the roof paint,

• Painting should be planned so that the paint has time to dry before the evening dew occurs.

App

The product should be at room temperature before application.

• The paint must be mixed thoroughly,

• Paint the prepared, dry surface with undiluted paint:

  • 2 times - when the substrate is covered with an undamaged coating,

  • 3 times - when the substrate is raw or has damage to the old coating.

The first coat can be applied to a highly absorbent substrate using paint diluted with a small amount of drinking water (up to 5%). Avoid over-diluting the paint, as this may affect its coverage and hiding power.

If excessive paint absorption into the substrate is observed during product application, stop painting and re-prime the surface.

The roof condition before and after applying Troken Roof-T paint.