SULFANOL A concrete degreasing agent

Concrete and roof tile cleaning agent

Sulfanol A is an alkaline preparation with strong wetting properties and a high capacity to break down fatty contaminants. The removed dirt particles form a suspension in water, allowing for their effective removal. The preparation has the ability to remove oil, grease, and fat stains from concrete surfaces, and thanks to its deep penetration, these stains are released to the surface, where they can be washed off with water. It can also be used to clean steel surfaces, effectively removing grease and oil from steel structures intended for painting.

Sulfanol A - properties

• Contains: water, surfactants, auxiliary agents,
• pH value: 9.0-10.0,
• Apply: with a brush, brush or spray.

Sulfanol A - surface preparation and application

• Concrete surfaces: To clean oil stains from concrete surfaces, apply the undiluted product to the surface to be treated, and then rinse with water, preferably under pressure, after approximately 10-15 minutes. For greater effectiveness, wash the surface with a brush. Repeat the process if necessary, especially in the case of heavy soiling. For minor contamination, the product can be diluted with water at a 1:1 ratio.
• Steel surfaces: Cleaning of steel structures from grease and oils intended for painting is carried out by applying the preparation undiluted, leaving for approximately 20 minutes to activate the agent, and then rinsing thoroughly with running water and drying.

In all cases, finish cleaning by rinsing with water. Leaving residue with contaminants may impair the adhesion of paint coatings to the substrate. We also offer a degreasing agent that is ideal for cleaning steel surfaces – Emulsol RN-1.